Stair treads are the heart of your home’s stairs. They’re designed to be safe and attractive, but they can also affect the way you move through your home. It’s important to know how to install carpeted stair treads properly so that you can enjoy them for years to come.
If you’re replacing your carpeted stairs with hardwood, this article will help you install the treads and moldings that will make them look like they’ve always been there. There are a few common carpets and stair treads that don’t require any special tools to install, but if you have specific needs for your project, our guide below should help.
What is a Stair Tread?
A stair tread is a single step that is found at the edge of stairs. Stairs are typically made out of wood, metal, or concrete, but there are other materials used as well. The treads are typically one inch wide and are placed 12 inches apart. Stair treads are usually made from a product which is called tread nosing. This material will be used to reinforce the stair portion of the footing where it meets up with adjacent building materials or other vertical surfaces. Whenever you require to discover detailed information on Wood countertops Houston.
The installation of carpeted stair treads
The following materials are needed: Clean Damp Cloth. Tape measure, scissors. Dual-sided carpet tape. The steps are:
- Prep the area. Wipe down the stairs with a damp cloth. Wait for it to dry.
- Once the surface is dry, place the tread backward on the step. Use the top of the step as a guide to cut the double-sided tape. It should be near the short end of the carpet tread. It should be about half an inch. After the tape is cut, stick it near the long edge of the tread. It should be about 1/2 inch away from the edge.
- Does this on the opposite side of the stair tread? Pull the carpet tape down to better secure it.
- Peel the film from the tape once the tape is secure.
- Set the carpet treads on the step by stepping over it gently. No pressing down yet. Measure the tread to make sure it’s centered. Aim for 0.5-1 inch away from the front edge of the step. Make sure it’s centered before you secure it. Turn the tread over. Secure the carpet tread by pressing along the long side of the tape.
- Keep doing this until you have attached all your treads.
Conclusion
It is best to have a professional carpet installer to install the carpet. Make sure that the stair treads are well attached and not loose. Stair treads should be installed at least one inch above the floor. Stair treads should be installed at least 1 inch above the floor to avoid damage due to excessive moisture, dirt, etc.
There are many different types of carpeted stair treads, so it’s important to know which type you need before you start the installation process. To help you out, we’ve prepared a guide that explains how to install carpeted stair treads.
